this is a concept of my new homemade project.the point of this is because my pump handle's air release hole got plugged and a vacumm effect was formed,so i plan to make a new one.
this is a rough picture of how it'll look like,to get a better picture,simply click on it.
basically i will remove the original pump head and throw on two rubber washer or gasket and hold it on with a screw.you will notice there's two holes on it those two holes acts as the air release holes to prevent the vacumm effect.now for a better explanation of the front.
you should roughly get the picture by now.
No comments:
Post a Comment